Separation and purification of two taxanes and one xylosyl‐containing taxane from Taxus wallichiana Zucc.: A comparison between high‐speed countercurrent chromatography and reversed‐phase flash chromatography

10‐Deacetylbaccatin III, an important semisynthetic precursor of paclitaxel and docetaxel, can be extracted from Taxus wallichiana Zucc. A process for the isolation and purification of 10‐deacetylbaccatin III ( 1 ), baccatin III ( 2 ), and 7β‐xylosyl‐10‐deacetyltaxol ( 3 ) from the leaves and branches of Taxus wallichiana Zucc. via macroporous resin column chromatography combined with high‐speed countercurrent chromatography or reversed‐phase flash chromatography was developed in this study. After fractionation by macroporous resin column chromatography, 80% methanol fraction was selected based on high‐performance liquid chromatography and liquid chromatography with mass spectrometry qualitative analysis. A solvent system composed of n‐hexane, ethyl acetate, methanol, and water (1.6:2.5:1.6:2.5, v/v/v/v) was used for the high‐speed countercurrent chromatography separation at a flow rate of 2.5 mL/min. The reversed‐phase flash chromatography separation was performed using methanol/water as the mobile phase at a flow rate of 3 mL/min. The high‐speed countercurrent chromatography separation produced compounds 1 (10.2 mg, 94.4%), 2 (2.1 mg, 98.0%), and 3 (4.6 mg, 98.8%) from 100 mg of sample within 110 min, while the reversed‐phase flash chromatography separation purified compounds 1 (9.8 mg, 95.6%) and 3 (4.9 mg, 97.9%) from 100 mg of sample within 120 min.     

A Bistable Microelectromechanical System Actuated by Spin-Crossover Molecules

We report on a bistable MEMS device actuated by spin-crossover molecules. The device consists of a freestanding silicon microcantilever with an integrated piezoresistive detection system, which was coated with a 140 nm thick film of the [Fe(HB(tz)₃)₂] (tz=1,2,4-triazol-1-yl) molecular spin-crossover complex. Switching from the low-spin to the high-spin state of the ferrous ions at 338 K led to a reversible upward bending of the cantilever in agreement with the change in the lattice parameters of the complex. The strong mechanical coupling was also evidenced by the decrease of approximately 66 Hz in the resonance frequency in the high-spin state as well as by the drop in the quality factor around the spin transition.     

One-step synthesis of VB2 powder by epoxy-assisted borothermal reduction of V2O5

Vanadium diboride was directly synthesized by borothermal reduction of V₂O₅ with the addition of epoxy resin as a reducing agent for the low-temperature reduction of vanadium(V) to vanadium(IV), which leads to the gradual removal of oxygen by the formation of CO gas. The slow rate of gas release prevents destruction of green body, which usually occurs during conventional borothermal reduction. This makes it possible to directly obtain VB₂ powder with an average particle size of 200–300 nm without need to prepare intermediate lower vanadium oxides.     

Determination of Mercury with a Miniature Sensor for Point-of-care Testing

In developing countries, subsistence gold mining entails mixing metallic mercury with crushed sediments to extract gold. In this approach, the gold−mercury amalgam is heated to evaporate mercury and obtain gold. Thus, the highly volatile mercury can be absorbed through inhalation, resulting in adverse health effects. Urinalysis can be used to detect mercury, which is excreted in urine and feces, and correlate exposure with toxic effects. The current gold standard analytical methods are based on fluorescence or inductively coupled plasma mass spectrometry methods, but are expensive, time consuming, and are not easily accessible in countries where testing is needed. In this work, we report on a miniature electrochemical sensor that can rapidly detect mercury in urine at levels well below the US Biological Exposure Index (BEI) limit of 50 ppb (μg/L). The sensor is based on a thin-film gold electrode and anodic stripping voltammetry electroanalytical approach. The sensor successfully detected mercury at trace levels in urine, with a limit of detection of ∼15 ppb Hg in the linear range of 20–80 ppb. With the low-cost disposable sensors and portable instrumentation, it is well suited for point-of-care applications.     

电感耦合等离子体质谱(ICP-MS)法测定土壤中的碘

通过电感耦合等离子体质谱法(ICP-MS)测定土壤中的碘。样品预处理采用艾斯卡试剂熔融、热水提取和阳离子树脂静态交换,试验加入了不同剂量的阳离子交换树脂在不同程度上降低了溶液中Na+ 和Zn2+^{等阳离子的盐效应干扰。研究了乙醇在}ICP-MS中对碘元素的增强效应,用3%的氨水溶液清洗进样系统,有效减少的碘的记忆效应和清洗时间。该方法线性范围宽,方法灵敏度高,检出限低,试剂用量少,环境友好。对苏州及周边区域若干非污染土壤点位进行采样、制备和测试,碘平均含量为2.7μg.g_-1^;同步测试国家有证标准物质,精密度和准确度良好。     

阳离子树脂交换分离-电感耦合等离子体质谱(ICP-MS)法测定地质石膏样品中硼

硼石膏近些年在水泥、沥青混合材料等领域应用广泛,其主要成分为CaSO4·2H2O和B2O3以及其他杂质,因此准确、快速测定石膏样品中的硼元素对石膏的应用、资源综合利用等方面具有重要意义。而国家标准GB/T 5484-2012《石膏分析方法》中并没有硼元素的化学分析方法,且相关文献报道也很少。目前测定硼元素主要采用电感耦合等离子体质谱法（ICP-MS）,样品前处理多采用酸溶法,而碱熔法应用不多,主要原因是碱熔后溶液中产生大量盐分影响等离子体焰的稳定性,而732型阳离子交换树脂能吸附大量的钠离子,同时吸附了钙、镍、铁及稀土等阳离子,减少盐分干扰。基于此原理,本文采用氢氧化钠碱熔-732型阳离子交换树脂交换分离,在线加入铑内标的方式,建立了ICP-MS法测定石膏中硼的方法,同时由于石膏国家标准物质不包含硼元素的含量,采用高纯硫酸钙分别与岩石标准物质、水系沉积物国家标准物质和土壤国家标准物质混合配置成人工标准物质,并讨论了熔矿体系、阳离子加入量与吸附时间、清洗液、同位素的选择等实验条件。本方法的检出限为0.76μg/g,精密度（RSD,n=7）为0.9%~1.7%,相对误差为1.56%~3.96%,加标回收率在97.5%~102%,该方法快速、准确,记忆效应小,适合石膏中硼元素的测定。     

Role of Cu-doping in CdTe thin films: Experiments and simulations

Due to its outstanding physical properties, CdTe is used to fabricate high efficiency solar cells. However, its high work function poses a challenge, and hence, to fabricate an efficient CdTe-based solar cell, Cu-doping may be useful. Here, we present the role of temperature-dependent Cu-doping in radio frequency sputter-deposited CdTe films and the related changes occurring in their optical, electrical, structural and microstructural properties. For instance, Cu-doping at different temperatures leads to an increase in the grain size and a reduction in the optical reflectance with increasing temperature. In addition, Kelvin probe force microscopy measurements reveal that the work function is found to be smaller corresponding to the annealing temperature of 473 K, whereas resistivity measurements show that it decreases with increasing temperature (the lowest value of resistivity is found to be 1.8 × 10⁻² Ω-cm). To understand the electronic structure of CdTe before and after Cu-doping, we have carried out first-principles density functional theory (DFT) simulation, which reveals a strong hybridization among Cu, Cd and Te atoms. This study paves the way to fabricate efficient Cu-doped CdTe-based solar cells.     

Sequential separation of Cu(II)/Ni(II)/Fe(II) from strong-acidic pickling wastewater with a two-stage process based on a bi-pyridine chelating resin

A self-synthesized bi-pyridine chelating resin (PAPY) could separate Cu(II)/Ni(II)/Fe(II) sequentially from strong-acidic pickling wastewater by a two-stage pH-adjusted process, in which Cu(II), Ni(II), and Fe(II) were successively preferred by PAPY. In the first stage (pH 1.0), the separation factor of Cu(II) over Ni(II) reached 61.43 in Cu(II)-Ni(II)-Fe(II) systems. In the second stage (pH 2.0), the separation factor of Ni(II) over Fe(II) reached 92.82 in Ni(II)-Fe(II) systems. Emphasis was placed on the selective separation of Cu(II) and Ni(II) in the first-stage. The adsorption amounts of Cu(II) onto PAPY were 1.2 mmol/g in the first stage, while those of Ni(II) and Fe(II) were lower than 0.3 mmol/g. Cu(II) adsorption was hardly affected by Ni(II) with the presence of dense Fe(II), but Cu(II) inhibited Ni(II) adsorption strongly. Part of preloaded Ni(II) could be replaced by Cu(II) based on the replacement effect. Compared with the absence of Fe(II), dense Fe(II) could obviously enhance the separation of Cu(II)-Ni(II). More than 95.0% of Cu(II) could be removed in the former 240 BV (BV for bed volume of the adsorbent) in the fixed-bed adsorption column process with the flow rate of 2.5 BV/h. As proved by X-ray photoelectron spectrometry (XPS) and density functional theory (DFT) analyses, Cu(II) exerted a much stronger deprotonation and chelation ability toward PAPY than Ni(II) and Fe(II). Thus, the work shows a great potential in the separation and purification of heavy metal resources from strong-acidic pickling wastewaters.     

利用高吸水树脂优化3个中学化学实验*

尝试利用高吸水树脂对“酸碱中和反应、碳酸钠和碳酸氢钠分别与稀盐酸反应、探究分子运动现象”这3个实验进行创新改进,充分利用了高吸水树脂特殊的结构作用,使3个实验的现象更加显著。改进实验操作简便,高效简洁,值得推广到一线化学课堂的演示实验或学生分组实验。     

Interface formation of Al2O3 on n‐GaN(0001): Photoelectron spectroscopy studies

Al₂O₃ insulator layers were deposited step by step by the physical vapor deposition (PVD) method onto gallium nitride in the wurtzite form, n‐type and (0001)‐oriented. The substrate surface and the early stages of Al₂O₃/n‐GaN(0001) interface formation were characterized in situ under ultra‐high vacuum conditions by X‐ray and ultraviolet photoelectron spectroscopy (XPS, UPS). The electron affinity (EA) of the substrate cleaned by annealing was 3.6 eV. Binding energies of the Al 2p (76.0 eV) and the O 1s (532.9 eV) confirmed the creation of the Al₂O₃ compound in the deposited film for which the EA was 1.6 eV. The Al₂O₃ film was found to be amorphous with a bandgap of 6.9 eV determined from the O 1s loss feature. As a result, the calculated Al₂O₃/n‐GaN(0001) valence band offset (VBO) is ?1.3 eV and the corresponding conduction band offset (CBO) 2.2 eV.